Posted in: Bike Rack, Costco

Bikes and A Rack

We didn’t really have a plan where to store the bikes when we bought them. The back bumper of the RV can only support 150 pounds. I was worried about being too close in weight with the combined weight of the bikes and a rack. We also did not have a rack attachment for the front of the truck.

Back bumper is welded on, so can only hold 150 lbs.

So far, Nick’s had been laying down in their room. Eventually we tried hooks to hang it off their bunks. That way did work, although we kept hitting our heads on the hooks when we went to get anything from the under bunk areas.

Will’s was wrapped in the outdoor rug and placed on the dinette once it was folded down for travel. (Which of course meant that everything was covered in a layer of dust/dirt when we unpacked again. Not a huge deal, but a little annoying.)

Once we got to a campground, we could chain them up outside, so it was a lot easier.

Ben saw a bike rack he thought would work while he was walking around the campground. It attached on the front of the RV, over the jack. After looking online, we found it at Camping World: the Jack-It Double Bike Rack. I checked online and it showed they had some in stock, so we headed over. Nope, they didn’t have any! The guy at the parts department told me to never trust the website, as it doesn’t update stock often. I called another Camping World to make sure they had it in stock and asked them to hold it for me (it was another 40 minute drive). They did hold it for me, and we also found a collapsible dish drying rack.

On our way back home, we stopped at Costco for some groceries and a pizza. Ben surprised me and bought me an electric bike for an early birthday present so I could ride with the boys, even if my ankle or knee are bothering me. The boys were very excited that I could ride bikes with them. Ben even took a ride on it.

Once home, we unpacked groceries and started to work on installing the bike rack. It took a little finagling to get it into place. To install it, we had to remove our electric jack. We then had to angle the Jack-It just the right way so we could slide the electric RV jack through the opening in the middle and not squish the jack’s electric cord.

We got it attached and arranged the bikes on it. We may have to play around with it a little more to get the bikes situated just right.

Back to Top